0
Shop
Close
3003-O VERSATUBE
See Below for Parts, Pricing, and Ordering

From $0.36 to $15.00
ADD TO CART

Enter the quantity desired of each item in the Buy column.

Click Add to Cart to add them to your shopping cart
or Add to Wishlist to store them for ordering later.

  • Overview
    Soft aluminum tubing for instrument air and vacuum lines, fuel and oil lines, and primer lines

    If mfg test reports are required there is a minimum $15.00 charge per order. Charge is higher if more than 5 items. P/N is “certs” - please indicate at time of order in the special instructions box.

    *Safety factor of 2.
  • Reviews

    Write a review

    by R C
    08/04/2017

    Bought for pitot, static line to run back the full length of the fuselage. With aluminum I do not have to worry about deterioration over the years. I have not installed yet but see no issues with it. Perfect straightness does not matter with the tubing as it will be out of sight in the fuselage.

    by Robert J
    11/24/2017

    Great stuff, exactly what I needed to repair a gas stove top. Bends by hand, standard brass ferrules worked perfectly.
  • Q+A

    Ask a question

    Do you have specs for weight per foot on the 1/8 and 1/4 aluminum versatube?
    The 1/8 inch is approximately .009 lbs per ft and the 1/4 inch is approximately .026 lbs per foot.

    Is this soft and bendable like copper tubing?
    Per the tech: short answer is yes. It is very similar in terms bend-ability to copper tubing.

    I need to use this for fuel line. Can it be flared to seal on AN fittings?
    Yes, 3003-O can be flared for use with AN fittings.

    The photo shows this 3003 is coiled. Can it be shipped straight?
    No, but 5052-0 alum tube is soft and is sold as straight tube. Not as soft as 3003, but can be bent and flared.

    Oops, I found the working pressures!
    Ok great, we are glad you found the info you were looking for.

    What is the ID of PN 03-40700? My fuel lines are 3/8 ID so I am debating between the 1/2 inch OD vs. 3/8 OD.
    03-40700 is 1/2" x .035" tube. I.D. is approx. .43".

    Can this 3003-0 tubing be used on GA aircraft? Does it have any FAA approval paperwork?
    If a maintenance/repair manual of a certified aircraft requires 3003-0 aluminum tube, then this can be used. It, like most raw materials, do not have an FAA approval, but meet material specifications, and this cert can be purchased. If required, the material cert must be ordered with the material, at the time of order.
Aircraft Parts
Pilot Supplies
Avionics Instruments
Building Materials
Engine Parts
Flight Training
Deal of the Day Shop by Aircraft Shop by Brand Order by Part #